Eventide H8000FW Spezifikationen PDF herunterladen (Seite 109)

103

10 + 12 = 22

22 - 16 = 6 SIX!

MIDI Running Status

It’s worth noting that MIDI commands are often sent on a MIDI connection only if the

command being sent differs from the last command sent. Between the occasional

command messages are data messages. A data message pertains to the last sent command

message. These are known as "Running Status."

You could send a MIDI command message to the H8000FW with the MIDI parameter

on the [midi] menu page in the SETUP area set to disabled. If you then change the MIDI

parameter to enabled, you must re-send the MIDI command message before the MIDI

data messages will be accepted. Try sending a different MIDI command to get things

started, or try cycling power on your MIDI source.

Automatically" Selecting a MIDI External Controller

As opposed to "manually" selecting a MIDI controller, along with its proper channel and

control number, a feature exists that "captures" the first MIDI message sent to the

H8000FW and uses it as the external controller. This works on both external modulation

and external trigger menu pages.

On the upper right-hand side of the screen, you

will find a function called Capture Midi.

Highlighting this parameter and pressing the

SELECT key puts the H8000FW in "Capture"

mode. The

mode parameter reads "CAPTURE."

The next type of MIDI message received by the H8000FW will be used for the mode

parameter, and the MIDI channel that it is received on will be used for the

channel

parameter. Of course, if you are in

omni mode, the channel parameter will remain

omni regardless of what channel the message is received on. To exit "Capture" mode without

"capturing," just press the

SELECT key again.

For example, if on the screen above (set to

"Capture" mode) we send a pitch bend message,

the screen to the right results. The

mode is set

pitch wheel.

At this point, we have discussed all of the parameters that are relevant to selecting an

external controller for modulation and triggering. If the external controller you would like

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 206 207

Keine Kommentare

Eventide H8000FW Spezifikationen Seite 109