Eventide H8000FW Spezifikationen PDF herunterladen (Seite 59)

Routing Configuration

Because of the large numbers of routing options

and possible configurations, routings are most

usefully loaded as presets, which can be accessed

by pressing and holding the PROGRAM key. In those cases where the factory-supplied

routings are not sufficient, time may be saved by picking the nearest one and making such

modifications as are required. The result can then be saved under a new name. For

completeness, a description of each routing option follows.

All the individual routing pages are accessed

from the main SETUP page.

Connecting real world inputs to the H8000FW

Different versions of the H8000FW support a wide range of possible inputs, as described

in the chart below. Be aware that, as described above, when using either effects unit

(DSP), the external inputs must be connected to the

MAIN Inputs

block. This limits the

number of channels that can feed the effects units to eight, the number of inputs to the

MAIN Inputs

block. In many cases, external inputs may be connected to external

outputs without this limitation, as described later.

Analog AES/EBU ADAT FireWire

H8000 2 channels 8 channels 8 channels

H8000A 4 channels 4 channels 8 channels

H8000FW 4 channels 12 channels 8 channels 16 channels

CONFIGURING THE MAIN INPUTS

The MAIN Inputs block is used as a binding post to select the inputs that are to be fed to

DSP A or DSP B. Each unit in the H8000FW series has a number of default inputs,

which only connect to the corresponding input of the MAIN Inputs block as shown

below:

The other inputs may be connected to any channel of the MAIN Inputs block.

 See Further input options to select SPDIF 1&2 or Analog 1&2 on the H8000.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 206 207

Keine Kommentare

Eventide H8000FW Spezifikationen Seite 59